Remove Motor Bracket - Maytag MDG25PN Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove motor (See page 4-27).
2. Remove two 1/4" hex head screws that
secure the bracket to base of dryer.
Two 1/4" Hex Head
Screws
3. Lift bracket to remove two tabs that pass
through dryer base and remove bracket
from dryer.
Two Tabs

rEMOvE MOTOr BrackET

4-28
TEcH TiP: To reduce excess vibration
transferred from the motor bracket to the
cabinet, place anti-vibration pads, if they
are missing, under the motor bracket.
Install two pads if possible, or if only one is
available then center it below the bracket.
Pads Pt #W10212660
Two Anti-Vibration