End Of Set-Up Procedures - Maytag MDG25PN Service Manual

CODE EXPLANATION
COIN/DEBIT OPTION
Both coin & debit selected. (NOT AVAILABLE)
Coins selected, debit disabled.
Press DELICATES key pad for this selection.
Debit Card selected, coin disabled. Default for PN models, and for
PN operation, must be set as J._d.
Press DELICATES key pad for this selection.
Enhanced debit is self-selected when a Generation 2 card reader
is installed in the dryer. The 'Ed' option cannot be manually
selected or deselected. (NOT AVAILABLE)
Press PERM. PRESS key pad once to advance to next code.
PRICE SUPPRESSION OPTION
This option is either SELECTED 'ON' OR NOT SELECTED 'OFF'.
This option causes the customer display to show 'AVAILABLE' or
'ADD' rather than the amount of money to add. (Used mainly in
debit installations.)
Not Selected 'OFF'.
Selected 'ON'. Press DELICATES key pad once for this selection.
Press PERM. PRESS key pad once to advance to next code.
CLEAR ESCROW OPTION
This option is either SELECTED 'ON' OR NOT SELECTED 'OFF'.
When selected, money held in escrow for 30 minutes without
further escrow or cycle activity will be cleared.
Selected 'ON'.
Not Selected 'OFF'. Press DELICATES key pad once to deselect
this option.
Press PERM. PRESS key pad once to advance to next code.
HUNDREDTH INCREMENT OFFSET
This represents the hundredth increment price offset used in
Generation 2 (Enhanced Debit) PN models. Choose from 0–4 hundredths
by pressing the WHITES AND COLORS key pad. (NOT AVAILABLE)
Press PERM. PRESS key pad once to advance to next code.
If cycle counter (9 0C) is selected, the
following is true:
1 00 Cycles in Hundreds
2 00 Cycles in Ones
This is "VIEW ONLY" and cannot be cleared.
Press the PERM. PRESS button once to
advance to next code.
1 02 = 200
2 25 = 25
TOTAL CYCLES = 225
If money counter (1.0C or 1.C0) is selected,
the following is true:
3 00 Currency in Hundreds
4 00 Currency in Ones
5 00 Currency in Hundredths
EnD OF SET-uP
PrOcEDurES
EXIT FROM SET-UP MODE
n PD MODELS: Reinstall service access door
n PN MODELS CONVERTED TO PR:
Remove set-up card
n PN MODELS where AA1 connector was
removed:
1. Unplug dryer or disconnect power.
2. Open console, reinsert jumper into AA1,
close console.
3. Plug in dryer or reconnect power.
n PN MODELS WHERE SERVICE ACCESS
CODE WAS USED:
From Set-up Code 8, press button #1 for 4
seconds. Wait 2 minutes without touching
any buttons (without diagnostic modes
running), or power down the dryer, then
reapply power.
PN MODELS WHERE KEY SWITCH
n
IS INSTALLED: Turn key clockwise and
remove key.
1-11
3 01 = 100.00
4 68 = 68.00
5 75 = 0.75
TOTAL = 168.75