Table of Contents
Advertisement
Transmit Delay (s)
Interface Advanced Options
Interface
Network
Cost
Priority
Authentication
Key ID
Key
Item
Passive Interface
Passive Interface
Network
IP Address
Netmask
Area ID
Area
Area ID
Range: 3-65535.
It will take time to transmit OSPF packets on the link. So a certain delay time
should be increased before transmission the aging time of LSA. This
configuration needs to be further considered on the low-speed link.
Range: 1-65535
Select interface.
Select OSPF network type.
Set the cost of running OSPF on an interface. Range: 1-65535.
Set the OSPF priority of interface. Range: 0-255.
Set the authentication mode that will be used by the OSPF area.
Simple: a simple authentication password should be configured and
confirmed again.
MD5: MD5 key & password should be configured and confirmed again.
It only takes effect when MD5 is selected. RanFE 1-255.
The authentication key for OSPF packet interaction.
Table 4-2-7-5 OSPF Parameters
Description
Select interface from "cellular0", "FE0" and "FE1".
The IP address of local network.
The netmask of local network.
The area ID of original LSA's router.
Set the ID of the OSPF area (IP address).
Figure 4-2-7-6
UR52 & UR55 User Guide
64
Advertisement
Table of Contents
