Table of Contents
Advertisement
OSPF
Item
Enable
Router ID
ABR Type
RFC1583 Compatibility
OSPF Opaque-LSA
SPF Delay Time
SPF Initial-holdtime
SPF Max-holdtime
Reference Bandwidth
Item
Interface
Interface
Hello Interval (s)
Dead Interval (s)
Retransmit Interval (s)
Description
Enable or disable OSPF.
Router ID (IP address) of the originating LSA.
Select from cisco, ibm, standard and shortcut.
Enable/Disable.
Enable/Disable
LSA: a basic communication means of the OSPF routing
protocol for the Internet Protocol (IP).
Set the delay time for OSPF SPF calculations.
Range: 0-6000000, in milliseconds.
Set the initialization time of OSPF SPF.
Range: 0-6000000, in milliseconds.
Set the maximum time of OSPF SPF.
Range: 0-6000000, in milliseconds.
Range: 1-4294967, in Mbit.
Table 4-2-7-4 OSPF Parameters
Figure 4-2-7-5
Description
Select interface from "cellular0" and "FE0".
Send interval of Hello packet. If the Hello time between two adjacent routers
is different, the neighbour relationship cannot be established. Range:
1-65535.
Dead Time. If no Hello packet is received from the neighbours within the
dead time, then the neighbour is considered failed. If dead times of two
adjacent routers are different, the neighbour relationship cannot be
established.
When the router notifies an LSA to its neighbour, it is required to make
acknowledgement. If no acknowledgement packet is received within the
retransmission interval, this LSA will be retransmitted to the neighbour.
UR52 & UR55 User Guide
63
Advertisement
Table of Contents
