Ursalink UR55 User Manual page 46

Item
ACL Setting
Default Filter Policy
Access Control List
Type
ID
Action
Protocol
Source IP
Source Wildcard Mask
Destination IP
Destination Wildcard
Mask
Description
ICMP Type
ICMP Code
Source Port Type
Source Port
Start Source Port
End Source Port
Destination Port Type
Destination Port
Start Destination Port
End Destination Port
More Details
Interface List
Interface
In ACL
Out ACL
Related Configuration Example
Access Control Application Example
Description
Select from "Accept" and "Deny".
The packets which are not included in the access control list will
be processed by the default filter policy.
Select type from "Extended" and "Standard".
User-defined ACL number. Range: 1-199.
Select from "Permit" and "Deny".
Select protocol from "ip", "icmp", "tcp", "udp", and "1-255".
Source network address (leaving it blank means all).
Wildcard mask of the source network address.
Destination network address (0.0.0.0 means all).
Wildcard mask of destination address.
Fill in a description for the groups with the same ID.
Enter the type of ICMP packet. Range: 0-255.
Enter the code of ICMP packet. Range: 0-255.
Select source port type, such as specified port, port range, etc.
Set source port number. Range: 1-65535.
Set start source port number. Range: 1-65535.
Set end source port number. Range: 1-65535.
Select destination port type, such as specified port, port range,
etc.
Set destination port number. Range: 1-65535.
Set start destination port number. Range: 1-65535.
Set end destination port number. Range: 1-65535.
Show information of the port.
Select network interface for access control.
Select a rule for incoming traffic from ACL ID.
Select a rule for outgoing traffic from ACL ID.
Table 4-2-2-1 ACL Parameters
UR52 & UR55 User Guide
46