Wireless Antenna - HP Desktop Pro A G2 Maintenance And Service Manual

Wireless antenna

The wireless antenna is secured to the front of the chassis with one screw. The antenna cable routes through
a hole in the front of the chassis, then under the power supply and to the WLAN module.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. If installed, remove the optical drive
5. Remove the drive cage
6. Remove the power supply
7. Disconnect the antenna cable from the WLAN module
8. Remove the Torx T15 screw that connects the antenna to the front of the chassis (1), and then pull the
antenna cable out through the hole in the front of the chassis (2).
To install the wireless antenna, reverse the removal procedure.
42 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 23).
(Removing the optical drive on page
(Removing the drive cage on page
(Power supply on page
17).
28)
40)
(WLAN module on page
16).
25)
19)