Table of Contents
Advertisement
Removing bezel blank
On some models, there may a bezel blank covering the optical drive bay. You must remove the bezel blank
before installing an optical drive. To remove a bezel blank:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Position the front bezel with the inside facing you.
5.
Press the four tabs that secure the bezel blank (one on each end, two in the middle) (1), and then push
the blank out from the inside to the outside of the front bezel (2).
24
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
17)
(Front bezel on page
23)
16).
Advertisement
Table of Contents
