Service Considerations; Power Supply Fan; Tools And Software Requirements; Screws - HP Desktop Pro A G2 Maintenance And Service Manual

Table of Contents

Advertisement

Service considerations

Listed below are some of the considerations that you should keep in mind during the disassembly and
assembly of the computer.

Power supply fan

The power supply fan is a variable-speed fan based on the temperature in the power supply.
CAUTION:
The cooling fan is always on when the computer is in the "On" mode. The cooling fan is off when
the computer is in "Standby," "Suspend," or "Off" modes.
You must disconnect the power cord from the power source before opening the computer to prevent system
board or component damage.

Tools and software requirements

To service the computer, you need the following:
Torx T-15 screwdriver
Flat-bladed screwdriver (may sometimes be used in place of the Torx screwdriver)
Phillips P2 screwdriver
Diagnostics software

Screws

The screws used in the computer are not interchangeable. They may have standard or metric threads and may
be of different lengths. If an incorrect screw is used during the reassembly process, it can damage the unit. HP
strongly recommends that all screws removed during disassembly be kept with the part that was removed,
then returned to their proper locations.
CAUTION:
Metric screws have a black finish. U.S. screws have a silver finish and are used on hard drives only.
CAUTION:
As each subassembly is removed from the computer, it should be placed away from the work area
to prevent damage.

Cables and connectors

Most cables used throughout the unit are flat, flexible cables. These cables must be handled with care to
avoid damage. Apply only the tension required to seat or unseat the cables during insertion or removal from
the connector. Handle cables by the connector whenever possible. In all cases, avoid bending or twisting the
cables, and ensure that the cables are routed in such a way that they cannot be caught or snagged by parts
being removed or replaced.
CAUTION:
When servicing this computer, ensure that cables are placed in their proper location during the
reassembly process. Improper cable placement can damage the computer.
Service considerations
13

Advertisement

Table of Contents
loading

Table of Contents