Drives; Drive Positions; Removing And Installing Drives; Removing The Optical Drive - HP Desktop Pro A G2 Maintenance And Service Manual

Table of Contents

Drives

IMPORTANT:

If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and

unplug the power cord. Do not remove a drive while the computer is on or in standby mode.

Before handling a drive, be sure that you are discharged of static electricity. While handling a drive, avoid

touching the connector. For more information about preventing electrostatic damage, refer to

discharge information on page

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as

monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the

package "Fragile: Handle With Care."

3.5-inch hard drive

2.5-inch hard drive or 9.5 mm optical drive

NOTE:

The drive configuration on your computer may be different than the drive configuration shown above.

When installing drives, follow these guidelines:

The primary Serial ATA (SATA) hard drive must be connected to the dark-blue primary SATA connector on

●

the system board labeled SATA0.

●

Connect a secondary hard drive or an optical drive to the SATA connector on the system board labeled

SATA1.

CAUTION:

All removable media should be taken out of a drive before removing the drive from the computer.

To prevent loss of work and damage to the computer or drive:

Electrostatic

Drives

Table of Contents