Download  Print this page

12 Power Cord Set Requirements; General Requirements; Japanese Power Cord Requirements - HP Desktop Pro A G2 Maintenance And Service Manual

Hide thumbs


12 Power cord set requirements

The power supplies on some computers have external power switches. The voltage select switch feature on
the computer permits it to operate from any line voltage between 100-120 or 220-240 volts AC. Power
supplies on those computers that do not have external power switches are equipped with internal switches
that sense the incoming voltage and automatically switch to the proper voltage.
The power cord set received with the computer meets the requirements for use in the country where you
purchased the equipment.
Power cord sets for use in other countries must meet the requirements of the country where you use the

General Requirements

The requirements listed below are applicable to all countries:
The power cord must be approved by an acceptable accredited agency responsible for evaluation in the
country where the power cord set will be installed.
The power cord set must have a minimum current capacity of 10A (7A Japan only) and a nominal voltage
rating of 125 or 250 volts AC, as required by each country's power system.
The diameter of the wire must be a minimum of 0.75 mm
between 1.8 m (6 feet) and 3.6 m (12 feet).
The power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or
against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits
from the product.
any manner, replace it immediately.

Japanese Power Cord Requirements

For use in Japan, use only the power cord received with this product.
Do not use the power cord received with this product on any other products.
Do not operate this product with a damaged power cord set. If the power cord set is damaged in
or 18AWG, and the length of the cord must be
General Requirements


Table of Contents

   Related Manuals for HP Desktop Pro A G2

Comments to this Manuals

Symbols: 0
Latest comments: