Devices To Be Prepared By The Customer; For The Cc-Link Ie Field Module - Mitsubishi 2F-DQ535 Instruction Manual

5.2. Devices to be Prepared by the Customer

5.2.1. For the CC-Link IE Field module

The devices which must be prepared by the customer to use the CC-Link IE Field module with the
Mitsubishi 2F-DQ535 card are listed below.
Device to be prepared
Master station
CC-Link IE Field
module
Ethernet cable
Switching hub
Driver for hex lobular
(torques) screw
Cross-point driver
Table 5-2 List of the standard items in the product
Master station compatible with CC-Link IE Field
An Anybus-CompactCom module by HMS
Anybus-CC CC-Link IE Field module (AB6709)
This cable must conform to the specification of CC-Link IE Field.
Category 5e (CAT 5e) or higher.
A shielded cable is recommended in noisy environment.
Always use a switching hub when using the I/O signal function.
* I/O signal data collisions will increase if a repeater hub is used.
Driver for module fixing part screws.
Prepare a size "T-10" screwdriver.
Used for card handle fixing screw.
5 Items to Be Checked Before Using This Product
Condition
Devices to be Prepared by the Customer 5-19
CC-Link IE Field