System Bios; Starting Setup; Parameter Descriptions - NEC Express5800 Maintenance Manual

Chapter 2 Convenient Features
1.

System BIOS

You can check and change the parameters using the BIOS Setup utility (SETUP).
1.1

Starting SETUP

Turn on the server and proceed with POST.
After a while, the following message appears at the bottom left of the screen.
Press <F2> SETUP, ... (* a different message may appear depending on the environment)
If you press <F2>, SETUP will start after POST, and the Main menu appears.
1.2

Parameter Descriptions

The SETUP utility has the following six major menus.
•
Main menu
•
Advanced menu
•
Security menu
•
Server menu
•
Boot menu
•
Save & Exit menu
These menu has submenus for relevant items. Selecting submenus allows you to configure further detailed
parameters.
Express5800/A1040b, A2040b, A2020b, A2010b Maintenance Guide
62
Note If Maintenance Mode is enabled, pressing the <F2> key does not launch SETUP, and the
Boot Selection menu appears. In addition, a message "The system is in Maintenance
Mode." is displayed instead of a message "Press <F2> SETUP, ...".
1. System BIOS