Worx Landroid WR130E Installation Manual page 7

Max.10cm
Max.2cm
Max.2.5cm
35% (20°)
35cm
Max. 35% slope
100cm
Length
Depressions and bumps
In case of large bumps (higher than 2cm) or dips (wider than
10cm and deeper than 2.5cm), please determine if the blades
would touch the ground or if Landroid
this is the case, either make the inclines smoother or exclude
these areas from Landroid 's operation.
®
Slopes
Your Landroid has the ability to safely climb slopes up to
®
35% (20°)**, so please avoid areas steeper than this.
**How to calculate the slope of your lawn:
The slope would be:
35cm (Elevation)
=35% (slope)
100cm (Length)
Placement of boundary wire on slopes
The upper boundary wire should NOT be placed on slopes
steeper than 35% (20°), and it should be placed at a distance of
26cm from any obstacle. The lower boundary wire should NOT
be placed on slopes steeper than 17% (10°), and it should be
placed at least 40cm away from any obstacle when positioned
on a slope that is 17%.
NOTE: The lower boundary wire cannot be laid across a slope
steeper than 17% as Landroid
wire, especially when the grass is wet.
Placement of boundary wire at a corner
If you want Landroid to turn a right angle, lay down the
®
boundary wire as the illustration shown.
would get stuck. If
®
will slip and cross outside the
®
7
EN