Worx Landroid WR130E Installation Manual page 13

>
26cm
>
26cm
>
26cm
>
26cm
>
10cm
>
26cm
OUT WIRE
90
o
OUT
>1m
>
26cm
>1m
>
26cm
>
10cm
>
26cm
75cm 75cm
IN WIRE
90
o
IN
4
Complete the entire boundary wire setup
Lay down the boundary wire around the working area as the
illustration shown.
After pegging the boundry wire, please take your Landroid
away from the charging base. Lead the boundary wire back to
the charging base, leave a length of the boundary wire (OUT-
wire) around 80cm and cut it off. Insert both wire ends into the
grooves on the charging base. Peel off the plastic skin at the end
of both wires (around 1cm), and connect the naked metal wire
end of the IN-wire to the BLACK terminal and the end of OUT-
wire to the RED terminal.
NOTE: If you need to extend the boundary wire, please refer
to "Joining the Boundary Wire" in Owner's Manual for
instructions.
®
13
EN