Worx Landroid WR130E Installation Manual page 11

Hide thumbs Also See for Landroid WR130E:

Enlarged version

WR130E WR131E

WR141E WR144E

BLACK

RED

Charge your Landroid

before the first operation

When connecting the power cord of the charging base to the

adapter, align the notch on the power cord (b) with the groove on

the adapter (a).

Connect the adapter to the electrical outlet. The LED on the

charging base will turn on in red color. Manually dock Landroid

into the charging base while Landroid

light on the charging base will turn green and Landroid

begin to charge.

If the power cord is in Landroid

if desired.

NOTE: If you want to plug the adapter in an indoor electrical

outlet, you need to route the power cord through the hole in the

wall.

Peg the boundary wire

Before pegging the boundary wire, it is recommended to use a

normal lawn mower or a grass trimmer to cut the grass along

the boundary. Then the wire should be laid as close as possible

to the ground to prevent your Landroid

wire. The boundary wire is powered with a very low voltage

totally safe to humans and pets.

Pull out a length of boundary wire around 80cm and fasten it

to the ground near the charging base. Later, this end of the

boundary wire (IN-wire) will be connected to the BLACK terminal

after pegging your boundry wire.

NOTE: The extended boundary wire should not exceed 400m or

it may cause signal problem.

is powered off. The green

will

's working area, you may bury it

accidentally cutting the