Worx Landroid WR130E Installation Manual page 15

Only for reference
5
Fine tune the outline shape of the boundary wire if necessary.
NOTE: If the boundary wire is broken during the testing or you need to extend the boundary wire, please refer to "Joining the
Boundary Wire" in Owner's Manual for instructions.
Check the status of the LED light indicator on the charging base to make sure the connection is OK.
If the verification test is completed smoothly, you can start mowing by pressing
If there is any problem during verification test, please refer to "Owner's manual-Troubleshooting" .
LED light indicator on the
charging base
Light does not turn on
Green light on
Red light on
Green light flashing
• If your Landroid
outside its territory, it will
not move and "
Warning
will be displayed.
Move it inside its territory
and repeat Verification.
NOTE: Please refer to the Owner's Manual for more information.
Status
There is no power.
Boundary wire is connected
successfully; Landroid is fully
®
charged.
The Boundary Wire isn't connected.
Power supply is connected
successfully, while the wire is
connected unsuccessfully.
Landroid is auto charging.
®
is • If your Landroid
®
inside its territory but
" " " is displayed,
please refer to "Error
Messages" in Owner's
Manual for solutions.
4
Press then to send Landroid
Landroid will follow the boundary wire to the charging base.
®
then
Action
Confirm that the power cord is connected properly to the
charger and that the charger is connected to a suitable
power supply.
/
Confirm that there are no breaks in the boundary wire.
Check that the boundary wire has been connected
correctly to the charging base.
Confirm that there are no breaks in the boundary wire.
/
is • Your Landroid
® ®
always remain switched
on. If you ever need to
turn it off, then make
sure you place it within
its boundary area
before you switching it
back on again.
back to the charging base.
®
.
should • Should your Landroid
stop operating, simply
restart it and operate it
as you normally would.
15
EN
®