Notifier AFP-200 Instruction Manual page 109

The CRT-2 must be set up to communicate with the control panel using the proper protocol. To enter the setup
menu on the CRT-2, hold down the CTRL button while pressing the SCROLL LOCK key. There are thirteen
groups of parameters that must be set. Each of these thirteen groups is reached by pressing the corresponding
function key (F1 – F13). Use the arrow key to move through each setup group and use the space bar to view the
options for each parameter.
F1
Emulation=Wyse-50+
Aux Baud Rate=2400
Aux Data Format=7/1/E
Host/Printer=EIA/Aux
F2
Emulation=Wyse-50+
Auto Font Load=On
Monitor Mode=Off
Warning Bell=On
F3
Page Length=24
Display Cursor=On
Columns=80
Scroll=Jump
F4
Language=U.S.
Keyclick=Off
Key Lock=Caps
F5
Enter Key=<CR>
Alt Key=Meta
F6
EIA Baud Rate=2400
Aux Baud Rate=2400
EIA Xmt=Xon-Xoff
Aux Xmt=Xon-Xoff
EIA Break=Off
Aux Break=Off
F7
Comm Mode=Full
Recv <DEL>=Ignore
Send Block Term=<CR>
AFP-200 Instruction PN 15511:F2
Comm Mode=Full Duplex
Enhanced=On
Language=U.S.
Enhanced=On
Auto Page=Off
Screen Saver=Off
Host/Printer=EIA/Aux
Screen Length=26 Lines
Cursor=Blink Block
Width Change Clear=Off
Refresh Rate=60 Hz
Char Set Mode=PC
Key Repeat=Off
Return Key=<CR>
Desk Acc=Disabled
EIA Data Format=7/1/E
Aux Data Format=7/1/E
EIA Recv=Xon-Xoff(XPC)
Aux Recv=Xon-Xoff(XPC)
EIA Modem Control=Off
Aux Modem Control=Off
Duplex Local=Off
Send ACK=On
Null Suppress=Off
10/11/99
EIA Baud Rate=2400
EIA Data Format=7/1/E
Sessions=One
Auto Wrap=Off
Auto Scroll=On
Bell Volume=09
Sessions=One
Screen Video=Normal
Auto Adjust Cursor=On
Speed=Normal
Overscan Borders=Off
Key Mode=ASCII
Margin Bell=Off
Backspace=<BS>/<DEL>
Pound Key=U.S.
EIA Parity Check=On
Aux Parity Check=On
EIA Xmt Pace=Baud
Aux Xmt Pace=Baud
EIA Disconnect=2 sec
Aux Disconnect=2 sec
Recv <CR>=<CR>
Send Line Term=<US>
109