• To configure the oscilloscope quickly, press the
• To undo the effects of Autoscale, press the
• To set the instrument to the factory-default configuration, press the
Example
Front-Panel Overview
To use analog channels to view a signal
To use analog channels to view a signal
the connect signal.
pressing any other key.
Save/Recall
key, then press the
Connect the oscilloscope probes for channels 1 and 2 to the Probe Comp output
on the front panel of the instrument. Set the instrument to the factory default
configuration by pressing the Save/Recall key, then the Default Setup softkey.
Then press the Autoscale key. You should see a display similar to the following.
Autoscale with analog channels
2- 12
Autoscale
Undo Autoscale
Default Setup
softkey.
key to display
softkey before