Test Set I/O Cable Installation; Interconnect Cable Verification - Keysight Technologies U3045AM04 User's And Service Manual

U3045AM04

Test Set I/O Cable Installation

Test Set I/O Cable Installation
1. Connect the Test Set I/O cable (N4011-21002) to the test set Interface
Figure 11 Test Set I/O Cable Connection

Interconnect Cable Verification

1. Perform the
2. If the problem still exists, perform the
3. If a power hole or other failure still exists, refer to
Keysight U3045AM04 User's and Service Guide
connector on the rear panel, similar to
"System Operational Check" on page
page 82.
Figure 11.
N4011-21002
18.
"RF Switching Failures" on page
"Contacting Keysight" on
63.
17