Keysight Technologies U3045AM04 User's And Service Manual page 18

U3045AM04
Front and Rear Panel Features
only a standby switch and is not a LINE switch. Alternatively, an externally
installed switch or circuit breaker (which is readily identifiable and is easily
reached by the operator) may be used as a disconnecting device.
Always use the three-prong ac power cord supplied with this product. Failure
to ensure adequate grounding by not using this cord may cause damage to
the product.
Power Cords
A line power cord is supplied in one of several configurations, depending on
the destination of the original shipment. Keysight can supply additional
certified power cords to meet region electrical supply and receptacle
configurations. Please contact Keysight at: www.keysight.com for assistance in
power cord selection.
The detachable power cord is the instrument disconnecting device. It
disconnects the mains circuits from the mains supply before other parts of
the instrument. The front panel switch is only a standby switch and is not a
LINE switch (disconnecting device).
Available Fuses
— Fuse (F 5 A/250V, 2110-0709) UL listed and CSA certified.
— Fuse (F 8 A/250V, 2110-0342) UL listed and CSA certified.
For continued protection against fire hazard, replace fuses, only with same
type and ratings. The use of other fuses, circuit breakers or materials is
prohibited.
Line Fuse
Figure 4
Verify that the premise electrical voltage supply is within the range specified
on the instrument.
12 Keysight U3045AM04 User's and Service Guide