Resetting The Device - ABB EQmatic Product Manual

ABB EQmatic
Device technology

Resetting the device

There are several ways to reset the device:
1. Restart (device reset only)
2. Restart and reset the network settings
3. Reset to factory settings
Reset button
To reset the device, use the Reset button. It is behind the label carrier (for more information see:
Connection diagram P.
described.
Press for
< 2 sec.
>2 sec. and
<10 sec.
> 10 sec.
< 20 sec.
> 20 sec.
20 2CDC512090D0202 | QA/S x.yy.1
11). Open the label carrier cover. Press the Reset button to reset the device as
Action
No reaction
1. Restart
Pressing and releasing the Reset button restarts the device.
2. Restart and reset the network settings
Pressing and releasing the Reset button resets the IP
address to automatic address assignment (DHCP) and
restarts the device.
3. Restart and reset to factory settings.
Pressing and releasing the Reset button deletes all user-
defined settings, network settings and database entries.
LED
ON LED (green): ON
M-Bus/Modbus RTU LED (yellow): ON
ON LED (green): Flashing (3 Hz).
M-Bus/Modbus RTU LED (yellow): ON
ON LED (green): Flashing (3 Hz).
M-Bus/Modbus RTU LED (yellow):
Flashing (3 Hz).
ON LED (green): Flashing (10 Hz).
M-Bus/Modbus RTU LED (yellow):
Flashing (10 Hz).
2.1.2