Meter Configuration (Qa/S 3.Xx.1 Energy Analyzer, M-Bus) - ABB EQmatic Product Manual

ABB EQmatic
Commissioning
3.2.1.1

Meter configuration (QA/S 3.xx.1 Energy Analyzer, M-Bus)

ABB EQ A4x and B2x meters are automatically detected after a scan and do not need to be
configured. Available data points, which depend on the meter type, are listed in the data points list.
If an M-Bus device is shown as Not Configured or Unknown after the scan, you must configure the
device and its data points. For this purpose, click the
meters.
Note
An M-Bus device is considered configured (status OK) as soon as one of the data points for
consumption has been configured.
Electricity meter:
Water meter:
Gas meter:
Heat meter:
32 2CDC512090D0202 | QA/S x.yy.1
Active energy (kWh)
Active power (W)
Volume (m³)
Volume (m³)
Active energy (kWh)
Edit button for the relevant device in All