ABB EQmatic Product Manual page 41

ABB EQmatic
Commissioning
Meters (QA/S 4.xx.1 Energy Analyzer, Modbus)
After a successful scan, all Modbus devices detected are shown along with the information they
provided in the Meters table below.
1 2
No.
1
2
3
4
5
6
7
8
9
10
11
1)
2)
3)
Note
The serial number of ABB meters is on the nameplate on the front of the device, e.g. 00019468.
40 2CDC512090D0202 | QA/S x.yy.1
3 4 5
Column header Description
Primary address
Shows the primary address set in the device.
1), 2)
1),
Status OK: Meter detected, configured and connected. System ready for operation.
NOT CONFIGURED:
Device model is linked to register mapping, however at least 1 data point is not configured.
Configure using
NOT IDENTIFIED
- Register mapping defined but meter model unknown or
- Register mapping defined but linked with wrong meter model.
DISCONNECTED:
- Device not connected to bus or has no power supply
Data points incorrectly configured in register mapping or not available in device
- Collision: Address conflict. Devices with same primary address and speed
1), 2)
Speed
Shows the speed set in the device
1)
Manufacturer Shows the manufacturer (max. 3 characters, e.g. ABB)
1)
Medium
Shows the medium to be measured on the device
1)
Version Shows the firmware version in the device
Place of Enter the place the device is installed here. This action is recommended so that the device is
3)
installation
easier to identify and assign on configuring the metering structure. Duplicate names are
allowed.
1), 3)
Meter name
For ABB meters, the type designation is used by default as the device name after a scan. This
can be overwritten. Enter a name for the device here. This action is recommended so that the
device is easier to identify and assign on configuring the metering structure. Duplicate names
are allowed.
1)
Serial number Shows the serial number (= secondary address) of the device
3)
Building node
Shows the assignment of the device based on the metering structure configured
Action Used to edit and configure the device
Opens the window for configuring the meter
Removes the device from the system
Is sent by the Modbus device
Needs to be set in the Modbus device
To be entered by user
6 7
.
10
8 9
11