Receiver Rear Panel Description - AMX CTC-1402 User Manual

Receiver Rear Panel Description

No. Name
1 HDBT IN
2 HDMI IN 1-2
3 HDMI OUT
4 AUDIO OUT
5 IR TX
6 RESET
7 12V
8 DEVICE
9 Host 1
10 Host 2
11 RS232-P
RS232-C
13 Relay 1
14 Relay 2
15 LAN 10/100
1-2
User Manual - CTC-1402
Description
Connect to the CTC-1402 transmitter via a shielded Cat 6A/7 cable.
Connect to an HDMI sources.
Connect to an HDMI display.
Connect to the audio system with the Phoenix Connector.
Connect to an IR emitter cable for emitting remote signal from TX.
When CTC-1402 RX is powered on, use a pointed stylus to hold down the RESET button for 3 seconds
or more, then release, the unit will reboot and restore to its factory defaults.
Connect to the provided DC 12V power adapter .
Connect to USB devices.
Connect to a PC which is followed with HDMI IN1, when the source is selected. The USB devices (on TX
and RX) can be connected to a host PC.
Connect to a PC which is followed with HDMI IN2, when the source is selected. The USB devices (on TX
and RX) can be connected to host a PC.
Connect an RS232 device to RS232-P of TX, and a device to RS232-P of RX for RS232 pass-through.
Connect to an RS232 slave device (such as a projector). Send commands via NetLinx Studio.
Connect to a screen with Phoenix Connector for closing the screen.
Connect to a screen with Phoenix Connector for opening the screen.
Connect to Ethernet devices.
14