Overcurrent Protection - SYMA GYRO REMOTE CONTROL SERIES User Manual

2.Over-Current Protection:
When the drone encounters direct impact
from a foreign object, or is obstructed, or
the blades are not rotating, the drone will
go into the over-current protection mode.
3.Level Calibration Function:
Place the drone on a level surface and at
the same time, push both left and right
joysticks to the lower right corners for 2
to 3 seconds; the indicator lights on the
drone will blink rapidly, and they will return
to solid status after about 2 to 3 seconds.
The level calibration is successful.
4.High/Low Speed Function:
Low speed by default when first powered-on.
Possible to switch the function mode of high/
low speed by pressing the right joystick for a
short time. It is switched into high speed mode
when two "beep" sounds come from the remote
control, pressing the right joystick for a short
time under fast speed mode and then one
"beep" sound would come from the remote
control, then it is switched back into low
speed mode.
5.360°Stunt Flip Function:
When you are familiar with the basic actions,
you can proceed to explore even more exciting
stunt actions. Fly the drone to a height of above
5 m above the ground, press the upper right
corner button (Stunt Flip Button) on the remote
control and simultaneously push the right
joystick to the farthest position of Front/Back/
Left/Right, the drone will now execute the
Front/Back/Left/Right stunt flip function.
Note: The drone will have the best stunt flip action when the batteries
are fully charged.
-7-