Product Features; Low-Voltage Protection; Overcurrent Protection - SYMA Gyro Remote Control Series User Manual

1. Battery Installation Method: Open up the battery cover at the back of the
remote control. Correctly place 4 x AA alkaline batteries in the battery
box in strict adherence to the polarity instructions (the AA alkaline
batteries are not included).

Product features

1. Low-voltage Protection:

When the two indicator lights at the rear of
the drone start flashing, it means that the
drone's battery power is low. At this time,
please control the drone return.The drone
will automatically slow down when it is
short of power.
2. Over-current Protection:
If the drone encounters a direct impact from
a foreign object,or is obstructed, or if the
blades are not rotating, the drone will go into
over-current protection mode.
3. Level Calibration Function:
Place the drone on a level surface and at
the same time, push both left and right
joysticks to the lower right corners for 2 to
3 seconds; the rear LED light indicator on
the drone will blink rapidly, and it will return
back to the normal status after about 2
to 3 seconds. The level calibration is
successful.
1. During the battery installation, it must be ensured
that the polarities of the batteries are matched with
that of the battery box. No battery shall be installed
with the opposite polarity.
2. Do not use new and old batteries together.
3. Different types of batteries are not be mixed.
4. Do not use rechargeable batteries.
(Flight control light) green
-5-
front indicator light
(WiFi signal light) red
rear indicator light