Setup / Basic Operation; Phono Operation - Victrola VTA-800B Instruction Manual

5-in-1 turntable

Hide thumbs

Table Of Contents

Table of Contents

Setup

1. Remove white protective needle cover by gently pulling towards front of unit.

2. Remove any packaging materials from the unit.

3. Connect the AC power cord to a wall outlet.

Note:

- It is strongly recommended that this product should be operated only from the type of power source

indicated on the marking label.

- To prevent interference, avoid bundling audio signal cables together with the AC power cord.

Basic Operation

1. Press the POWER button to turn the unit on.

2. Select the function by pressing the FUNC button

3. Press the VOL+/VOL- to adjust to the desired sound level.

RCA LINE OUT

For amplifier device listening, first reduce the volume level to minimum.Insert the white and red plugs

on the RCA cable into the unit, then insert the opposite end into the amplifier device. Be sure to connect

the white plug to the white jack and the red plug to the red jack.

Earphones/Headphones (not included)

For private listening, first reduce the volume level to minimum.

Insert your headphones' plug into the 3.5mm jack, then

adjust the volume by pressing VOL+/VOL-.

Note: The speakers will automatically be deactivated while

headphones are plugged in.

CONDENSATION WARNING:

When the unit is moved from a cold or warm place, or is used following a sudden temperature change, there is the

danger that water vapor in the air may condense on the unit, preventing proper operation. In such cases, leave the unit

for 1-2 hours after plugging it into an AC outlet to allow it to stabilize at the temperature of its surroundings.

1. Press the FUNC Button until the LCD Display indicates "PHON".

2. Gently open the top cover.

Note: Gently lift up the cover all the way until it stops. To close the top lid,

gently lift up and pull in the hinge towards the front of the unit and gently

lower the lid. Be careful not to pinch your finger.

3. Place a vinyl record on the turntable. When playing a 45 RPM record, use

the included adaptor.

4. Select the appropriate speed according to the record.

5. Gently lift the tone arm up from the tone arm holder and move the tone arm to the edge of the

record (or the starting point of a track). The turntable will automatically begin to spin.

7. When the record reaches its end, tone arm will stop at the center of the record and you must lift and

return the tone arm to the tone arm rest manually.

Important:

- Closing the top cover will help prevent dust from settling on the turntable.

- Do not place anything on top of the turntable cover, especially while playing a record.