Setup / Basic Operation; Listening To The Fm Radio; Listening To An External Audio Device (Bt Mode) - Victrola PLAZA Manual

Setup
1. Remove white protective needle cover by gently pulling towards front of unit.
2. Remove any packaging materials from the unit.
3. Connect the AC power cord to a wall outlet.
Note:
-It is strongly recommended that this product should be operated only from the type of power source
indicated on the marking label.
-To prevent interference, avoid bundling audio signal cables together with the AC power cord.
Basic Operation
1. Rotate the POWER/VOLUME knob clockwise to turn the unit on.
2. Select the source by rotating the selection knob (PHONO /FM/BT/ AUX).
3. Rotate the POWER/VOLUME knob to adjust to the desired sound level.
Listening through RCA LINE OUT
For amplifier device listening, first reduce the volume level to minimum. Insert the white and red plugs
of the RCA cable into the corresponding colors on the unit. Then insert the opposite end into the
amplifier device. Be sure to connect the white plug to the white jack and the red plug to the red jack.
Listening through Earphones/Headphones (not included)
For private listening, first reduce the volume level to minimum.
Insert your headphones' plug into the 3.5mm jack, then
adjust the volume up by turning the VOLUME knob.
Note: The speakers will automatically be deactivated while
headphones are plugged in.
CONDENSATION WARNING:
When the unit is moved from a cold or warm place, or is used following a sudden temperature change, there is the
danger that water vapor in the air may condense on the unit, preventing proper operation. In such cases, leave the
unit for 1-2 hours after plugging it into an AC outlet to allow it to stabilize at the temperature of its surroundings.
1. Rotate function knob to select "FM" function.
2 Tune to the desired station by using the Radio Tuner Knob.

Listening to an External Audio Device (BT Mode)

In BT (Bluetooth) mode, this unit can play music from an external device with the Bluetooth feature.
GETTING CONNECTED USING BLUETOOTH
1. Rotate to select "BT" function. The Bluetooth indicator will flash.
2. Set the Bluetooth function of your external device when the apparatus is on.
3. Set to search Bluetooth device on your external device.
NOTE: The effective distance between your external device and this apparatus is 33 ft (10 meters).
4. When "VTA-810B" appears on the paired devices list on your external device, press "VTA-810B"
to connect. If a password is required, use "0000" then press "OK" on your external device.
5. When your Bluetooth connection is successful, Bluetooth LED indicator will remain lit.
NOTE: The Fast Forward/Rewind function is only available on your external device.

Setup / Basic Operation

Listening to the FM Radio

8