Victrola VTA-800B Instruction Manual page 9

1. Press the FUNC Button until the LCD Display indicates "CD --".
(Note: When no disc is inserted, "disc" will appear on the display.)
2. Press the OPEN/CLOSE
(Note: This button only works in CD mode.)
3. Place a disc on the tray with the printed label face up.
4. Press the OPEN/CLOSE button
5. The CD playback will start automatically.
6. To temporarily pause playback, press the PLAY/PAUSE button (
7. To skip tracks backward or forward, press the corresponding skip button (
once will restart the current track. Pressing
the previous track.
8. To fast forward / rewind within a track, press and hold down the corresponding skip button until the
desired position is reached.
9. To stop playback, press the STOP
Important:
- Never place more than one disc on the tray.
- The disc must be placed in the center of the disc tray.
An incorrectly loaded disc can permanently damage the tray door mechanism.
- Do not push the CD tray – always use the OPEN/CLOSE button.
- It takes a moment for the unit to load a disc, during which all buttons will be temporarily deactivated.
Repeat Playback
Each time the REPEAT button is pressed, the repeat mode will cycle through the following options:
REPEAT 1 (Repeat one track)
Press the REPEAT button once and the current track will be played on repeat. REPEAT ONE will
appear on the display. If you press the (
select will be played repeatedly.
REPEAT ALL (Repeat the entire CD)
Press the REPEAT button again and ALL tracks on the current disc will be played continuously.
REPEAT ALL will appear on the display and the entire CD will be played repeatedly.
SHUFFLE
Press the REPEAT button again to shuffle songs.
Programmed Playback
Up to 20 tracks can be programmed to play in a set order (with CD Discs only).
1. Select "CD" mode, then load a CD.
2. While the CD is stopped, press the PROGRAM button.
3. "PROGRAM" indicator lights up and "P01" blinks on the display.
4. Press ( or
5. Press the PROGRAM button again to set the next program track, "P02" appears and blinks.
Repeat steps 4 thru 5 to program the additional tracks.
6. When the selection of track numbers has been finished, press the PLAY button (
playback. (Note: when all 20 program tracks are set, press the PROGRAM button and "FI" will
appears on the display)
7. To cancel programmed playback, press the STOP
To check the programmed order
In the stop mode, press (
programmed.
To add a track to the end of the programmed order:
In stop mode, press the PROGRAM button.
CD Operation
button.
to close the tray.
button.
) to select a track number.
or ) repeatedly to show the track numbers that have been
twice quickly will return to the beginning of
or ) button to select another track, the track you
button until the program indicator disappears.
9
). Press again to resume.
or ). Pressing
) to start program