Seat System; Replacing Seat Suspension/Spring - Invacare Leo Service Manual

Invacare® Leo
6.
Cut through cable ties (1) and remove.
7. Fold up controls shroud (2).
8.
Remove motor cable plug (1) from controls system.
9. Remove motor cable.
10.
Fold drive to the rear onto enclosure and antitipper.
11. Remove wheels (1). (see chapter 6.3)
12.
Loosen motor fixing bolts (1) on both sides and
remove.
24
13. Remove motor downwards out of the mobility device
frame.
14.
Check rubber bearing (1) on motor suspension.
Replace damaged rubber bearings.
15. Install motor in reverse order.
16. Secure motor cable with cable tie.
17. Complete installation of mobility device.
18. Test all functions.

4.10 Seat system

4.10.1 Replacing seat suspension/spring

WARNING!
Risk of accident
Accidental rolling can lead to accidents.
– Secure mobility device against rolling away.
When removing, note position of small parts such
as screws and washers. Put small parts down so
that they can be installed in right sequence.
The following seat support tubes are available for
seat suspension:
User weight
0–136 kg
136 – 160 kg
• 17 mm open wrenches
1. Secure mobility device against rolling away.
2. Remove seat.
3. Loosen securing bolt of seat support tube.
Length of seat support
tube
508,5 mm
533,5 mm
558,5 mm
508,5 mm
533,5 mm
558,5 mm
1509707-E