Replacing Center Brake Light; Replacing Rear Lights/Direction Indicators - Invacare Leo Service Manual

5.
Remove screws (3) on glass.
6. Remove glass.
7. Loosen screws (4) on orange-colored cap (5) and
remove cap.
8. Replace lightbulb.
9. Install parts in reverse order.
10. Test function.

4.5.3 Replacing center brake light

CAUTION!
Risk of burning if power cable is shorted
– Turn off the power completely before
removing any power supply components of
the mobility device. Therefore take out the
batteries.
– Avoid bridging of contacts during
measurements on live electrical components.
When disassembling, note the position of small
parts such as screws and washers. Put small parts
down so that they can be reassembled in the right
sequence.
• Phillips screwdriver
1. Remove seat.
2. Remove shroud.
3.
Disconnect battery cable A.
1509707-E
4.
Disconnect plug (4).
5.
Remove bolts (1) on rear shroud.
6. Lift the rear shroud upwards.
7.
Remove screws (1) on brake light.
8. Replace brake light.
9. Install parts in reverse order.
10. Test functions (trial run).

4.5.4 Replacing rear lights/direction indicators

CAUTION!
Risk of burning if power cable is shorted
– Turn off power completely before removing
any power supply components of mobility
device. Therefore take out batteries.
– Avoid bridging of contacts during
measurements on live electrical components.
When disassembling, note the position of small
parts such as screws and washers. Put small parts
down so that they can be reassembled in the right
sequence.
• Phillips screwdriver
Service
15