Setting Up The List Of Send Msns For The Next Call; Setting Up A Busy Signal When The Msn Is Being Used (Busy On Busy) - Siemens Gigaset CX203isdn Owner's Manual

Setting up the list of send MSNs for the next call

You can set up your base station so that after lifting the receiver or pressing the
handsfree key d a list of all available send MSNs is displayed.
By factory default, MSN next call is not activated.
i
s
Set base
s
Settings
~
OK
s
Setup user
s
Setup device
s
INT11: Int.11
s
MSN next call
j

Setting up a busy signal when the MSN is being used (Busy on Busy)

This setting allows callers to get a busy signal immediately when an external call is
already being made on this MSN, independent of the setting Call waiting.
By factory default, the function is not set.
i
s
Set base
s
Settings
~
OK
s
ISDN settings
s
Busy on busy
j
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 89).
Select the menu item and confirm.
OK
Select the menu item and confirm. The list of
OK
entered internal numbers is displayed.
W
Select internal number of the terminal and open the
submenu, e.g. INT11: Int.11.
Select the menu item and confirm (
OK
Hold down (back to idle status).
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 89).
Select the menu item and confirm.
OK
Select and confirm (
OK
Hold down (back to idle status).
System settings
‰
= activated).
‰
= activated).
95