Battery Regeneration Function - BRAND Transferpette-8 electronic Operating Manual

Battery display after
inserting a battery
Note: After inserting a battery always charge 3.5 hours!

Battery regeneration function

(Refresh function)
In order to extend the service life and to optimize performance of the battery, the Transferpette
electronic has a regeneration function (refresh function). This program provides a controlled full
discharge and recharging of the battery. To optimize the battery performance, this refresh function
should be used periodically.
Perform the refresh
function
Interrupting the discharge-charge cycle
Press any button to end the program. The instrument switches automatically to the standard pipette
mode (PIP) and to the nominal volume and the normal charging process is started automatically, see
page 62. Removing the plug for the AC adapter also ends the program.
Charging and Replacing the Battery
a) After the battery is inserted, the display
shows the full capacity indicator with a
blinking frame, the instrument does not
recognize the charging status right now.
After 3.5 hours of charging time – safe full
charging of the battery – the frame stops
blinking.
a) Insert the plug for the AC adapter into the
jack on the top of the Transferpette
electronic.
b) Press and hold the lower
arrow key (>3 sec). During
the discharging process, the
capacity bars for the battery
indicator run continually from
the top to the bottom.
c) After the controlled discharge (up to
3 hours), the charging process (3.5 hours)
is started automatically. During charging,
the capacity bars run continually from the
bottom to the top.
® -8/-12
1x >3s
®
-8/-12
63