Winder
To set the winder spacing:
7. Turn the winder spindle (6) such that the thread-pulling knife (5) is
8. Loosen the threaded pin in the block (8).
9. Set the winder lever (3) such that the upper arm is above the marking
The distance between the winder lever and the outer thread on
10. Set the block (8) such that it is resting against the locking disk (9).
11. Set the block (8) such that its distance to the winder wheel (10)
12. Tighten the threaded pin in the block (8).
Setting the winder run
Fig. 58: Setting the winder (4)
(8) - Block
(10) - Winder wheel
(12) - Threaded pin
To set the winder run:
13. Loosen the threaded pin (13).
14. Set the switch cam (14) such that it is just contacting the leaf spring (15)
15. Set the switch cam (14) such that the winder lever (3) has no axial play.
16. Tighten the threaded pin (13).
Service Instructions 869-M PREMIUM - 00.0 - 07/2018
at the top right and is facing the right-hand screw hole (7).
for the XXL hook (11).
the bobbin is 2 – 3 mm.
is 0.5 mm.
⑧
⑩
⑫
⑬
when the block (8) has engaged in the locking disk.
⑭
(13) - Threaded pin
(14) - Switch cam
(15) - Leaf spring
⑭
⑮
73