DURKOPP ADLER 869-M Premium Service Instructions Manual page 128

Test Ana. Input subitem
1. Select the desired element with the
2. Confirm the selected element.
3. Observe the display on the control panel.
 If the element is functional, the corresponding value is displayed.
Test Auto Input subitem
Fig. 93: Test Auto Input subitem
In this subitem, you can carry out the same tests as under
without having to select the element beforehand via the display.
To perform the test steps:
1. Confirm the element.
 In Input, the display shows the number of the element last changed.
Test Sew. Motor subitem
Use this subitem to test the functionality of the sewing motor.
To check the sewing motor:
1. Press the OK button.
 The machine performs a reference run.
2. In the
Fig. 94: Test Sew. Motor subitem
3. Press the OK button to confirm the input.
 The sewing motor runs at the entered speed.
4. To end, press the OK or ESC button.
126
If the element is functional, the display switches between On and Off
under Value.
field, use the
Speed
buttons in the
/
Eingang :
Wert :
buttons to enter a speed in steps of 100.
/
Nähantrieb
Drehzahl:
200
Service Instructions 869-M PREMIUM - 00.0 - 07/2018
Programming
field.
Input
Test
Input