Table of Contents
Advertisement
Setting the winder filling quantity
The position of the arms (4) on the winder lever (3) determines the filling
quantity:
4. Turn the screw (2):
5. Put the completely filled bobbin onto the winder.
6. Fold the winder lever (3) upwards as far as it will go to the thread.
Setting the winder spacing
Fig. 56: Setting the winder (2)
(3) - Winder lever
(5) - Thread-pulling knife
(6) - Winder spindle
(7) - Right-hand screw hole
Fig. 57: Setting the winder (3)
(11) - Marking for XXL hook
72
• Parallel: Automatic winding stop at 0.5 mm below the edge of
the winder
• Closer together: Automatic stop with larger filling quantity
• Further apart from each other: Automatic stop with smaller filling
quantity
• Arms (4) closer together: turn counterclockwise
• Arms (4) further apart from each other: turn clockwise
⑤
⑥
⑦
⑩
③ ⑧
(8) - Block
(9) - Locking disk
(10) - Winder wheel
⑪
Service Instructions 869-M PREMIUM - 00.0 - 07/2018
Winder
⑨
⑤
⑥
Advertisement
Table of Contents
