Table of Contents
Advertisement
Menu item
Mode
Transport
Pressure
SwitchOff
AlwaysOn
Top
Down
108
Setting options
Setting defining which puller roller is supposed to run.
Mechanic
Both rollers freewheel passively; mechanical coupling only
Top+Bot
Both wheels run actively under power
Upper
The upper roller runs actively under power
Transport mode of the rollers
constant
Even transport
intermittent
Transport adapted to the rhythm of the machine's feed dog
Setting of the start and stop angle under Start/Stop has been
adapted to the machine. The values should not be changed.
Set the puller pressure
Yes
Pressure is supplied constantly and regulated via the gage at the puller.
HPNo
Pressure is generated actively except for the 2nd stroke height.
No
No active pressure from puller.
Puller is not active when the sewing motor is stopped. Holding force
of the roller is off; sewing material can be pulled out from between
the rollers.
Puller is always on even when raised.
Settings of the upper puller roller.
Transmission, puller
Transm.
(Value range 00.0 – 65.0)
Motor current, puller
Drive
(Value range 0.0 - 5.0 [A])
No-damage current, puller
Hold
(Value range 0.0 - 5.0 [A])
Diameter, roller
Diameter
(Value range 0000 – 9999 [mm])
Rotational direction, roller
Direction
0 = right
1 = left
0 = non-regulated (controlled operation)
ClosedLoop
1 = regulated
Settings of the lower puller roller - identical to the settings of the upper
puller roller.
Service Instructions 869-M PREMIUM - 00.0 - 07/2018
Programming
Advertisement
Table of Contents
