Router Connection Mode; Part 1: Configuring The Adsl Router - Siemens E-110 User Manual

Router Connection Mode

In this deployment environment, we make up a private IP network of 192.168.1.1. NAT function is enabled
(on ADSL Router or use another NAT box connected to hub) to support multiple clients to access the
Router and some public servers (WWW, FTP).
If you apply for multiple IP addresses from your ISP, you can assign these public IP addresses to the ADSL
Router and public server, e.g., Web or FTP server. Typically the first IP is network address, the second is
used as router IP address and the last one is subnet broadcasting. Other remaining IP addresses can be
assigned to PCs on the LAN.
This section describes both RFC1577 and 1483 Bridge connection methods.

Part 1: Configuring the ADSL Router

1. Creating an ATM VCC interface.
1. Select Wan > ATM VC.
2. On the ATM VC Configuration
3. Enter the provided fields as below:
Field
VC Interface
VPI / VCI
Mux Type
Max Proto per AAL5
4. After entering the fields above, click [Apply].
5. When confirmation page appears, click [Close].
6. You will return to the
Rev:01_040220
page click [Add] to add a new ATM VCC interface.
Description
Select a VCC interface from the available interfaces, e.g. aal5-2.
Enter the VPI/VCI values given by your ISP, e.g. 0 / 34.
Select LLC or VC as required by your ISP.
Keep the default 2.
ATM VC Configuration page and see the newly added ATM VC entry.
Chapter 5: Connection Mode
77