Committing Changes To Permanent Storage; Rebooting The Device Using Configuration Manager - Siemens E-110 User Manual

Field
Use DNS
Primary DNS Server /
Secondary DNS Server

Committing Changes to Permanent Storage

Whenever you change system settings, the changes are initially placed in temporary storage (called
random access memory or RAM). Your changes are made effective when you submit them, but will be lost
if the device is reset or turned off.
Follow these steps to commit changes to permanent storage.
1. Select Admin > Commit & Reboot. The
2. Click [Save]. (Disregard the selection in the Reboot Mode drop-down list; it does not affect the
commit process.)
The changes are saved to permanent storage.
When committing your changes, note that:
If you change the LAN IP address information, you must commit the changes and then reboot the
system to activate them.
All other changes are activated when you commit them (no reboot is needed).

Rebooting the device using Configuration Manager

If, after rebooting the device, you find that it does not operate properly with the new configuration, you
can reboot using options that reactivate a previous configuration or the manufacturer's default
configuration.
You can select from the following options when rebooting:
Setting
Reboot From Default Configuration
Reboot From Backup Configuration
Reboot From Last Configuration
Rev:01_040220
Description
Enable
Enter the Primary and Secondary DNS server addresses provided by your ISP
Commit & Reboot
Description
Reboots the device to default settings provided by your ISP or the
manufacturer. Choosing this option erases any custom settings.
Reboots the device using settings stored in backup memory.
These are the settings that were in effect before you committed
new settings in the current session.
Reboots the device using the current settings in permanent
memory, including any changes you just committed.
Chapter 3: Configuration
page displays.
37