Siemens E-110 User Manual page 89

Appendix: Specification
Software
ADSL Compliance
ANSI T1.413 Issue 2
ITU G.992.2 Annex A (G.lite)
ITU G.992.1 Annex A (G.dmt)
ITU G.992.1 Annex B (G.dmt)
ITU G.994.1 (G.hs)
ATM Features
Compliant to ATM Forum UNI 3.1 / 4.0 Permanent Virtual Circuits (PVCs)
Support up to 8 AAL5 Virtual Circuit Channels (VCCs) for UBR, CBR and GFR service classes
Provides ATM layer functionality
Provides adaptation layer (AAL5) functionality
Performs the traffic shaping and scheduling per ATM port
Supports PPP encapsulation over ATM (PPPoA) and PPP over Ethernet (PPPoE)
ADSL-aware CAC
Support for F5 AIS, RDI and loopback cells
Bridging Features
Up to 1000 hosts
Supports transparent bridging as specified in IEEE 802.1D Transparent Bridging
Supports bridged PDU encapsulation (RFC 2684)
MAC-level filter to accept/deny packets based on rules applicable at the MAC level
Routing Features
Network Address Translation (NAT)
IP filtering and raw filtering
Dynamic IP address allocation is supported through DHSP and IPCP
Point-to-point Protocol (PPP): PPPoA, PPPoE, PAP or CHAP for user authentication, Routing information
Protocol (RIP) v1 and v2
Security Features
PAP (RFC1334), CHAP (RFC1994) for PPP session
Firewall support IP packets filtering based on IP address/Port number/Protocol type and TCP code field
flags
Intrusion Detection provides protection from a number of attacks (such as SYN/FIN/RST Flood, Smurf,
WinNuke, Echo Scan, Xmas Tree Scan, etc)
Configuration and Management
DSL Forum TR37-compliant auto configuration
SNMPv1 over DSL or Ethernet for access to the MIB-II (router only)
CLI (Command Line Interface) via serial interface or Telnet over Ethernet or DSL
Web-based Graphical User Interface (GUI) enabling end-user device configuration via Web browser
Update of boot image configuration data over TFTP/FTP
Rev:01_040220
Appendix: Specification
83