vacuubrand Peltronic Instructions For Use Manual page 26

Connecting the outlet of the pump to the exhaust waste vapor con-
denser Peltronic
+ Establish connection with the formed PTFE hose included in delivery.
➨ Slip union nuts on hose. Fasten the PTFE hose with union nuts at the
tube fittings. If necessary widen the hose ends a bit by heating (538°F
(280°C) at maximum).
page 26 of 44
:
®
+ Depending on the pumping unit the formed
(1)
PTFE hose has to be cut accordingly.
Attention: Do not crush the PTFE hose, in
case use hose cutter (see section „Acces-
sories", pg. 35).
+ Pumping units comprising a diaphragm
pump with four pump heads and PC 2002:
Assemble formed hose as delivered (1).
+ Pumping units comprising diaphragm pumps
with two pump heads (except PC 2002): Cut
angled hose 90 mm x 60 mm (2).
+ MD 1C AK + EK: Cut straight piece of hose.
Length of 91 mm.
(2)
+ PC 2001: Cut straight piece of hose. Length:
85 mm. Mechanical fastening only possible
with special holding plate. Operation is also
possible with free-standing condenser.
Hose cutter (see section „Accessories", pg.
35)
Attention: The blade of the hose cutter is
very sharp. Risk of injury!