Use And Operation; Assembling Components; Mounting The Exhaust Waste Vapor Condenser Peltronic - vacuubrand Peltronic Instructions For Use Manual

Use and operation

Assembling components

catchpot
Separation of condensate:
The round bottom flask is coated with a protective layer to prevent disin-
tegration in case of breakage.
+ Separation of condensate: Remove joint clip, remove catchpot and
drain condensate.
Important: Comply with applicable regulations when disposing sol-
vents. Reuse if possible, purify if contaminated.

Mounting the exhaust waste vapor condenser Peltronic

at VACUUBRAND pumping units with compact exhaust
waste vapor condenser
+ For mounting the exhaust waste vapor condenser Peltronic
VACUUBRAND pumping units with compact exhaust waste vapor
condenser, an assembly kit (see section „Accessories", pg. 35) is re-
quired. The assembly kit contains corresponding assembly instructions.
Mounting the exhaust waste vapor condenser Peltronic
at VACUUBRAND pumping units with exhaust waste va-
por condenser of older design
holding block
page 25 of 44
Catchpot
➨ Assemble the catchpot at the condenser
using the joint clip.
Mechanical fastening:
➨ Dismount water cooled exhaust waste va-
por condenser.
➨ Screw the exhaust waste vapor condenser
Peltronic together with the holding block
®
with two socket-head screws to the holder
at the pump support.
®
at
®
®