Setting Up And Installing The Equipment - vacuubrand Peltronic Instructions For Use Manual

Use the equipment only as intended, that is, for conden-
NOTICE
sation of emitted vapors at the outlet of vacuum systems
and pumps (i.e. at atmospheric pressure). Any other use
will automatically invalidate all warranty and liability claims.
Remain aware of safety and risks.

Setting up and installing the equipment

between +50°F and +104°F (+10°C and +40°C). Peri-
odically check maximum temperatures if installing the
equipment in a cabinet or a housing. Make sure venti-
lation is adequate to maintain recommended operating
temperature. Install an external automatic ventilation
system if necessary.
If pumping hot process gases, make sure that the max-
imum permitted gas inlet temperature is not exceeded.
• Ensure that the exhaust waste vapor condenser
Peltronic , and any accessories in the flow path are
®
chemically resistant to the processed substances prior
to operation.
➨ Equipment must be connected only to a suitable elec-
trical supply and a suitable ground point. As such,
the plug must be plugged into an outlet that is properly
grounded. Failure to connect the motor to ground may
result in deadly electrical shock.
The supply cable may be fitted with a molded Europe-
an IEC plug or a plug suitable for your local electrical
supply. The cable contains wires color coded as fol-
lows: green or green and yellow: ground; blue or white:
neutral; brown or black: hot.
+ Do not permit any uncontrolled pressurizing. Make
sure that the exhaust pipeline cannot become blocked.
If there is an exhaust isolation valve, make sure that you
cannot operate the equipment with the valve closed to
avoid a risk of bursting!
page 12 of 44