Maintenance And Repair - vacuubrand Peltronic Instructions For Use Manual

An excess temperature protection switches off the con-
denser in case of excess temperature.
Attention: The condenser will start automatically after
sufficient cooling down. It is your responsibility to ensure
that automatic start-up of the condenser will not lead to
any dangerous condition. Provide appropriate safety mea-
sures.

Maintenance and repair

In order to comply with laws (occupational, health and
NOTICE
safety regulations, safety at work law and regulations for
environmental protection) equipment can only be returned
when certain procedures (see section „Repair - Mainte-
nance - Return - Calibration", pg. 37) are followed.
➨ Never operate the equipment if parts are disas-
sembled.
➨ Switch off the exhaust waste vapor condenser
Peltronic . Disconnect the electrical power cord
®
and wait five seconds before starting maintenance
to allow the capacitors to discharge.
➨ Note: The exhaust waste vapor condenser Peltronic
may be contaminated with chemicals, which have
been processed during operation. Ensure that the ex-
haust waste vapor condenser Peltronic
decontaminated before maintenance commences.
+ Take adequate precautions to protect people from the
effects of dangerous substances if contamination has
occurred. Use appropriate protective clothing, safety
goggles and protective gloves.
+ Never operate a defective or damaged exhaust
waste vapor condenser Peltronic
page 18 of 44
is completely
®
.
®
®