Safety During Operation - vacuubrand Peltronic Instructions For Use Manual

Peltronic with air or inert gas prior to changing the
®
processed media. Purging the exhaust waste vapor
condenser Peltronic
will reduce the possibility of reactions of the processed
substances with each other and with the condenser's
materials.

Safety during operation

➨ Adopt suitable measures to prevent the release of dan-
gerous, toxic, explosive, corrosive, noxious or polluting
fluids, vapors and gases. To prevent any emission of
such substances from the condenser outlet, install an
appropriate collecting and disposal system and take
protective action for exhaust waste vapor condenser
Peltronic and environment.
®
➨ You must take suitable precautions to prevent any for-
mation of explosive mixtures in the condenser or at its
outlet. In case, hot surfaces or static electricity may
ignite these mixtures.
➨ Drain appropriately or otherwise remove any potential-
ly explosive mixtures at the outlet of the condenser, or
dilute them to non-explosive concentrations.
➨ Never operate this equipment if it has a damaged cord
or plug.
+ If the condenser is not working properly, has been
dropped or has fallen into water, contact your service
provider.
+ Make sure that the exhaust pipeline cannot become
blocked.
+ Comply with applicable regulations when disposing of
chemicals. Take into consideration that chemicals may
be contaminated. Take adequate precautions to pro-
tect people from the effects of dangerous substances
page 16 of 44
will clean it from residues and it
®