Handling And Transport - EBARA JEU Operating Instructions, Installation & Maintenance Manual

Ebara Self Priming Jet Pumps

Handling and Transport

Unpacking
Check that there are no breaks or severe dents in the packing. If there are, point
this out immediately to the person who delivered the material. after removing the
pump from the package, check that it has not suffered any damage during shipping.
If damage is found, inform the distributor within 8 days of delivery. Check that
the specifications stated on the plate of the pump are the same as requested in
your order.
Handling and Disconnecting
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE THE
PUMP TO FAIL, SUFFERING SEVERE DAMAGE.
DO NOT USE THE POWER CABLE TO LIFT OR DRAG THE PUMPS.
To handle or disconnect the pump you must:
• remove the plug from the power socket and/or turn off the switch (if
included);
• remove the discharge pipe if necessary;
• remove the suction pipe if necessary;
• roll up and hold the electric power cable in your hand;
• lift the pump in both hands;
• if the pump has a handle, fit it and anchor it well.
If the pump is set up for fixed applications, perform the following operations
to move it; however, before lifting it, unscrew the screws that fasten the pump to
the surface that it stands on.
Transport
The pump is packed in a cardboard box for transport; as its total weight and
bulk are not excessive shipping presents no problems. However, check the total
weight marked on the box.
before installation, check that the characteristics stated on the plate of the
pump are the same as you requested in your order and ensure that it has
suffered no damage.
Ebara Fluid Handling
www.pumpsebara.com
(803) 327-5005 • (803) 327-5097 fax
JEU
6
rev. 01/12