Mount The Standard Motor To The K4 Or K5 Short Adapter - Siemens SIMOGEAR BA 2039 Operating Instructions Manual

Installing
3.5 Mounting the motor
3.5.2

Mount the standard motor to the K4 or K5 short adapter

Note
Ensure that the plastic ring
The plastic ring
①
②
1505 Bolt
Image 3-4
Procedure
1. Check the correct position of the plastic ring
required.
2. Align the position of the motor shaft so that you can insert it in the shaft
not need to be greased.
3. Apply adhesive (medium strength, e.g. Loctite 243) to the bolts 1505.
4. Fasten the motor with the bolts 1505 with the prescribed torque. See Thread sizes and
tightening torques for fastening bolts (Page 17).
You have mounted the standard motor on the K4 or K5 adapter.
22
ATEX version gearboxes
Impacts can cause sparks.
Apply adhesive (medium strength, e.g. Loctite 243) to the bolts 1505.
①
①
prevents fretting rust. It does not need to be greased.
Plastic ring
Shaft
Plastic ring for K4 and K5
is located in the correct position.
①
in the shaft. Correct the position if
Operating Instructions, 04/2016, A5E37431501A/RS-AC
Correct Incorrect
②
. The shafts do
BA 2039