Operation - Siemens SIMOGEAR BA 2039 Operating Instructions Manual

Adapter for gearbox

Hide thumbs Also See for SIMOGEAR BA 2039:

Table of Contents

Operation

Malfunctions can cause injuries or gearbox damage

In the event of changes during operation, the drive unit must be switched off immediately.

Use the fault table in the section titled "Faults, causes, and remedies" to determine the

cause of the fault. Remedy faults or have faults remedied.

Check the gear unit during operation for:

● Excessive operating temperature

● Changes in gear noise

● Possible oil leakage at the housing and shaft seals

BA 2039

Operating Instructions, 04/2016, A5E37431501A/RS-AC

ATEX version gearboxes

The difference between the temperature of the housing and the ambient

temperature of max. +40 °C must not exceed 70 K.

Using a suitable temperature sensor, measure the temperature at the lowest point

of the housing (oil sump) or at the mounting surface in the case of output units.

Changes are an indication of possible incipient damage.

CAUTION

Table of Contents