Table of Contents
Advertisement
Installing
3.4 Mounting an input or output element on the gearbox shaft
NOTICE
Premature wear or material damage due to misalignment
Misalignment caused by excessive angular or axis displacement to the connecting shaft
ends.
Ensure precise alignment of the individual components.
NOTICE
Damage caused by improper handling
Bearings, housing, shaft and locking rings are damaged due to improper handling.
Do not use impacts or knocks to force the input and output elements to be mounted onto
the shaft.
Note
Deburr the parts of elements to be fitted in the area of the hole or keyways.
Recommendation: 0.2 x 45°
Where couplings are to be fitted in a heated condition, observe the specific operating
instructions for the coupling. Unless otherwise specified, apply the heat inductively using a
torch or in a furnace.
Use the center holes in the shaft end faces.
Use a fitting device to fit the input or output elements.
Image 3-1
Observe the correct mounting arrangement to minimize stress on shafts and bearings due to
lateral forces.
18
Example of a fitting device
Operating Instructions, 04/2016, A5E37431501A/RS-AC
BA 2039
Advertisement
Table of Contents
