Assemble Profibus Cable Pb Fc Standard Cable Gp With Data Connector Ie Fc Rj45 Plug 4X2 For 2-Wire Transmission Function - Siemens SIMATIC BusAdapter BA 2xRJ45VD HA Operating Instructions Manual

Note
If you use cables with a length > 500 m, connection establishment can take up to 2 minutes.
Note
If you connect a BusAdapter BA 2xRJ45VD HA to existing PROFIBUS cabling, the same
requirements relating to shield contact and the lightning protection concept apply as for
PROFIBUS.
Installing the bus connector
Install the PROFINET connector according to the instructions in the PROFINET Installation
Guide (http://www.profibus.com/download/installation-guide/).
Accessories required
Please observe the specifications in the PROFINET Installation Guide
(http://www.profibus.com/download/installation-guide/).
5.3.1 Assemble PROFIBUS cable PB FC Standard Cable GP with data connector IE
FC RJ45 Plug 4x2 for 2-wire transmission function
Required components
● 1 PROFIBUS cable PB FC Standard Cable GP
● 2 data connectors IE FC RJ45 Plug 4X2
You will find the corresponding article numbers in the section "Accessories (Page 12)".
Required tools
● Stripping tool
– IE FC stripping tool
– Green blade cassette
● Stripping pliers
● Diagonal cutter
● Screw driver, 2.5 mm
You will find the corresponding article numbers in the section "Accessories (Page 12)".
SIMATIC BusAdapter
Operating Instructions, 06/2018, C79000-G8976-C472-01
Connection
5.3 Industrial Ethernet
29